OBC 2006 › Division B
9.24.1.
Version 0 — in force 31 December 2006
This looks wrong
Tell us what is wrong and we will verify & correct our mapping.
- Edition
- OBC_2006
- Division
- B
- Provision
- 9.24.1.
- Version
- v0
(1) This Regulation comes into force on December 31, 2006.
Read directly from the regulation's own commencement section.
O. Reg. 350/06 · commencement 2.2.1.1(1)
This version stayed in force until the next edition replaced it. What follows is that edition’s base regulation’s commencement — the takeover that ended this one.
(1) Subject to Sentences (2) and (3), this Regulation comes into force on January 1, 2014.
Read directly from the regulation's own commencement section.
O. Reg. 332/12 · commencement 4.4.1.1(1)
This looks wrong
Tell us what is wrong and we will verify & correct our mapping.
- Edition
- OBC_2006
- Division
- B
- Provision
- 9.24.1.
- Version
- v0
(1) This Regulation comes into force on December 31, 2006.
Read directly from the regulation's own commencement section.
O. Reg. 350/06 · commencement 2.2.1.1(1)
This version stayed in force until the next edition replaced it. What follows is that edition’s base regulation’s commencement — the takeover that ended this one.
(1) Subject to Sentences (2) and (3), this Regulation comes into force on January 1, 2014.
Read directly from the regulation's own commencement section.
O. Reg. 332/12 · commencement 4.4.1.1(1)
Provenance
OBC 1997 · continues from 9.24.1. — Pro
Base · O. Reg. 350/06 · ext← current
Original — base regulation
OBC 2012 · continues as 9.24.1. — Pro
9.24.1. — General
Content not available for this version.
9.24.1.1. — Application
(1) This Section applies to sheet steel studs for use in non-loadbearing exterior and interior walls.
(2) Where loadbearing steel studs are used, they shall be designed in conformance with Part 4.
Text · e-Laws consolidated snapshot
9.24.1.2. — Material Standards
(1) Steel studs and runners shall conform to CAN/CGSB-7.1, “Lightweight Steel Framing Components”.
Text · e-Laws consolidated snapshot
9.24.1.3. — Metal Thickness
(1) Metal thickness specified in this Section shall be the minimum base steel thickness exclusive of coatings.
Text · e-Laws consolidated snapshot
9.24.1.4. — Screws
(1) Screws for the application of cladding, sheathing or interior finish materials to steel studs, runners and furring channels shall conform to ASTM C1002, “Steel Self-Piercing Tapping Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs”.
Text · e-Laws consolidated snapshot
9.24.1.5. — Cladding, Sheathing and Interior Finish Required
(1) Cladding or sheathing, and interior finish shall be installed on steel stud framing and shall be fastened with screws,
(a) spaced at the appropriate spacing described in Section 9.29., and
(b) penetrating not less than 10 mm through the metal.
Text · e-Laws consolidated snapshot
Provenance
OBC 1997 · continues from 9.24.1. — Pro
Base · O. Reg. 350/06 · ext← current
Original — base regulation
OBC 2012 · continues as 9.24.1. — Pro