OBC 2006 › Division B
9.29.7.
Version 0 — in force 31 December 2006
This looks wrong
Tell us what is wrong and we will verify & correct our mapping.
- Edition
- OBC_2006
- Division
- B
- Provision
- 9.29.7.
- Version
- v0
(1) This Regulation comes into force on December 31, 2006.
Read directly from the regulation's own commencement section.
O. Reg. 350/06 · commencement 2.2.1.1(1)
This version stayed in force until the next edition replaced it. What follows is that edition’s base regulation’s commencement — the takeover that ended this one.
(1) Subject to Sentences (2) and (3), this Regulation comes into force on January 1, 2014.
Read directly from the regulation's own commencement section.
O. Reg. 332/12 · commencement 4.4.1.1(1)
This looks wrong
Tell us what is wrong and we will verify & correct our mapping.
- Edition
- OBC_2006
- Division
- B
- Provision
- 9.29.7.
- Version
- v0
(1) This Regulation comes into force on December 31, 2006.
Read directly from the regulation's own commencement section.
O. Reg. 350/06 · commencement 2.2.1.1(1)
This version stayed in force until the next edition replaced it. What follows is that edition’s base regulation’s commencement — the takeover that ended this one.
(1) Subject to Sentences (2) and (3), this Regulation comes into force on January 1, 2014.
Read directly from the regulation's own commencement section.
O. Reg. 332/12 · commencement 4.4.1.1(1)
Provenance
OBC 1997 · continues from 9.29.7. — Pro
Base · O. Reg. 350/06 · ext← current
Original — base regulation
OBC 2012 · continues as 9.29.7. — Pro
9.29.7. — Hardboard Finish
Content not available for this version.
9.29.7.1. — Material Standard
(1) Hardboard shall conform to CAN/CGSB-11.3-M, “Hardboard”.
Text · e-Laws consolidated snapshot
9.29.7.2. — Thickness
(1) Hardboard shall be not less than,
(a) 3 mm thick where applied over continuous back-up,
(b) 6 mm thick where applied to supports spaced not more than 400 mm o.c., and
(c) 9 mm thick where applied to supports spaced not more than 600 mm o.c.
Text · e-Laws consolidated snapshot
9.29.7.3. — Nails
(1) Nails for fastening hardboard shall be casing or finishing nails not less than 38 mm long, spaced not more than 150 mm o.c. along edge supports and 300 mm o.c. along intermediate supports.
Text · e-Laws consolidated snapshot
9.29.7.4. — Edge Support
(1) All hardboard edges shall be supported by furring, blocking or framing where the back-up is not continuous.
Text · e-Laws consolidated snapshot
Provenance
OBC 1997 · continues from 9.29.7. — Pro
Base · O. Reg. 350/06 · ext← current
Original — base regulation
OBC 2012 · continues as 9.29.7. — Pro